Please charge it overnight, then try again! It does sound like it ran out of battery somehow. Also the fact that it doesn’t seem to charge beyond 72% is worrying.
Now after more than ten hours connected to the (original) PSU (and USB-C Cable) the battery status is at 82% with ~ 1 hr 43 min remaining. Is that a normal cyclus? How long does a full battery load take usually? Thanks!
Just saw this with matches to my LEDs while charging (with original equipment):
“* Do you see red/blue flashing LED on plugging in the charger? This means the power adapter you’ve connected is not supported. Please use the supplied power adapter.”
@SchmuFoo yes you should contact support to get a replacement power adapter and cable first. Only send in your projector if that doesn’t solve the problem. You can also purchase any inexpensive 60W power adapter, which will charge the projector when off, at reduced 45W power since most of them can’t supply 4A current.
Also, if I remember correctly you have a 2nd PPX coming up, you can also try with that power adapter.